Biofield harmonizing is basically a pure harmonization of the organism. In other words, as a rule, nothing is changed in the interference zone, but the body is provided with the corresponding balancing frequencies.

The basis for understanding this type of spatial harmonization is provided by bioresonance. Paul Schmidt recognized and scientifically described already at the beginning of the 70’s that everything around us, as well as above all also in us vibrates in completely certain frequencies. Each frequency has both polarities, plus and minus. If there is an imbalance in one of the frequency values, i.e. a polarity shift, disharmony arises and later usually illness.

For example, if a person stays on an irritation zone – e.g. caused by a water vein – the polarity shifts on one or more certain frequencies and the body is weakened. If one knows the corresponding frequency values, one can make them available to the body in the room with the help of special resonators or as pure information.

In addition to the specific regulation level of the HOME BALANCE – FM Biofield Harmonizer, the main focus in the development of the module was placed on the energy factor.

What is the use of a system that gives the body instructions to feel certain radiation fields differently, or even a system that manages to counteract an interference zone by individually adaptable counter-vibrations, if the energy value, very well definable by the bovis value, remains in a range that vibrates lower than the human being?

Due to the law of negative entropy, the human being loses life energy on such fields. That means, independent of the stressing radiation spectrum, above all, the energy value of the place must be raised to at least a neutral value, otherwise important regulation processes in the body can no longer take place.

The FM Biofield Harmonizer balances out energetic deficits on all interference zones, so that the person no longer loses energy there.

If a mains disconnect switch or mains decoupler is active, the module should not be plugged into the enabled bedroom.

In such cases, a BIOGETA® Bio-Wafer is very well suited as a supplement. This would then provide locally under the respective beds for a removal of the interference zones, while the FM Biofeld Harmonizer provides at central place during the day for a balance.‘

However, a part of the compensating frequencies also arrives in the sleeping areas despite the network decoupler. And this is through lines in the neighboring, or underlying rooms.

In some cases, this is even sufficient for complete cancellation of the interference zones during the night, even without using an additional Bio-Wafer.

The modules do not consume anything. The silicon core oscillates the information through a membrane onto a conductor and thus onto the house current.

The energy that the module needs is the natural oscillation property of the crystalline core.

It is quasi free energy, because it provides the oscillation of the core. Basically, every crystal – including silicon – vibrates due to free cosmic energy.

Basically, there are two ways to build such modules. The first possibility would be – without going into detail – that certain information is stored on a carrier, in this case the silicon core of the module, and then releases it to the environment.

The second possibility is to install only an instruction on the core, after which a certain field is generated again and again. This is comparable to a vector path, where start and end points are defined, and the intervening distance is built up again and again. This allows vectors to be scaled arbitrarily without losing quality, whereas a bitmap, for example, consists of pixel points that quickly become blurred when zoomed in.

In comparison with FM Biofield Harmonizer, these are constructed like a vector. This means that as long as the core can oscillate, a constant field will keep building up without losing quality.

If you ever feel that the power has dropped, unplug the module and walk around your home with it for a few minutes. This will cause the core to resonate again and release the full frequency spectrum.

However, by using the mains decoupler that matches the modules, this is no longer necessary and the module remains permanently oscillating.

Die Basis der Module ist Silizium. Es ist quasi ein kleingeraspelter Microchip.

Silizium besitzt eine kristalline Struktur und ist in der Lage feinste Informationen und Anweisungen zu speichern und entsprechend umzusetzen. Deshalb wird Silizium in der Computerindustrie verwendet, und deshalb dienen z.B. Quartz Kristalle als Taktgeber in Uhren.

Der Vorteil eines Silizium-Kritsalls besteht in seiner Schwingungseigenschaft. Er ist somit der perfekte Transmitter, um die Regulations-Informationen auf den Stromkreis aufzuschwingen.

A question that is asked very often, concerns the sizes of the modules. It is important to understand that the recommended size of the modules depends on the size distribution of the circuit and the resistances in it (branches, fuses, etc.).

It is not that a larger module produces „more energy“, but has more volume, and oscillates more. But it is the same information structure. The aim is to delete the existing interference zones by interference, to balance the body in polarities and to raise „negative“ Bovis values to the ambient level.

It is therefore possible to use an L-size module in a small apartment without any problems. In case of doubt, we always advise to take the larger module instead of the smaller one.

As a rule, it is often the case that at the latest 4 weeks after a BIOGETA® module has been put into operation, there is no longer any evidence of exposure to water veins, earth grids or NF electrosmog or HF electrosmog in the body.

However, this does not necessarily mean that all symptoms that have arisen up to that point have disappeared directly. It usually takes a little longer.

The FM Biofeld Harmonizer balances the polarities and „negative“ oscillation areas, so that we no longer lose energy, our cells do not depolarize and the vegetative nervous system is balanced.

The new series of modules works very gently, so you will probably notice only after a few days that you would like to stay in bed longer and overall calm down.

In the first few days you may even experience some restlessness, as the body often has to get used to the changed oscillation field first.

YES! The main efficiency of an FM Biofield harmonizer is within the meter circuit of the corresponding dwelling. Experience has shown that the meter is too great a resistance for the information to be transmitted across it to the rest of the house current.

However, if you have direct neighbors, they may also be able to benefit from your balancing vibration field through the cables laid in your walls. The same applies to apartments above.

However, by far not the same effect can be expected as if the module is active directly within the apartment circuit.

Basically, it does not matter where the module is plugged in, because the regulation information is modulated on the 50Hz of the house current and thus distributed everywhere in the house / apartment.

Experience shows that the best results are achieved when the module is plugged in on the same floor as the bedrooms or living room.

We recommend plugging it directly into a free wall socket and only in an emergency into a multiple socket.

In order to calculate the correct size, it is important to understand how the Biofield Harmonizer works.

It modulates a packet of information onto the 50Hz of the power grid and thus distributes itself throughout the house – or within the meter circuit. This means that not only the inhabited rooms, but also other rooms where wires are installed must be added to the area. E.g. basement rooms, garages, carports and/or the attic.

For the latter, it is usually sufficient to calculate 1/3 of the total area of the attic, because usually only one pipe goes up there. The same is true for most garages. However, if the attic is developed, it must be included with full floor space.